Title: Using Search to find all Font (Or anything else!!) Post by: Elmer BeFuddled on September 12, 2010, 05:11:33 pm Hi, Sorry if this is (trust me, it is!!) total Noob.
I wanted to change all fonts in the basic aero.msstyles from Segoe UI to Arial. I finally managed this in little spurts by a manual search. BUT. I tried to use the search function by:- FONT, Font, FONT:FONT, Segoe, Segoe UI but each search attempt returned no results (hence the manual bit!!). Did I miss something off when searching for all font entries, i.e. a wild card? If I did would I use the same (syntax) wild card for alternative searches (e.g. a colour). Thanks for your patience. Elmer Title: Re: Using Search to find all Font (Or anything else!!) Post by: 3am on September 12, 2010, 05:32:36 pm Search for font in properties. It will show you every location with a font.
Search Segoe in values. It will show you every location with a Segoe font. Use the drop down menu on the Search Box (arrow on right) to find properties, values etc. Title: Re: Using Search to find all Font (Or anything else!!) Post by: Elmer BeFuddled on September 12, 2010, 05:43:58 pm Search for font in properties. It will show you every location with a font. Search Segoe in values. It will show you every location with a Segoe font. Use the drop down menu on the Search Box (arrow on right) to find properties, values etc. Thankyou 3am (F@@k Sh!t 'n' B@ll@x!, I knew I'd forgotten something!) I just found all fonts in 15 seconds, as opposed to spread over 15 hours! |